Mobile Optics Side and Rear View Camera - Monitor Installation

NOTE: Make sure you have read and understand all instructions and procedures before installation. (If you are not confident you can operate the tools needed to perform this installation safely and correctly STOP!!! and call your local dealer for a certified installer in your area.)

Monitor & Adapter Mounting

Mounting the 3.5" LCD Monitor:
Find a suitable location for the monitor for visibility and easy of use. This is usually on the center of the headliner console or drivers' side visor. Affix monitor with adhesive donut to desired location. Tuck monitor cable under headliner towards drivers side cab corner post. Route cable under plastic cover down through the corner and side of dash to fuse box. Connect red wire (power) to source found at fuse box during the pre-installation test. Connect black wire (ground) to suitable nearby ground.

Mounting the 5.6 " LCD Monitor:
Find a suitable location for the monitor for visibility and easy of use. With the universal mounting kit provided the monitor can be mounted on the dash or to the overhead. When selecting the location be sure to consider where and how the cable will be run. Mount the universal mounting plate with the adhesive, 4 screws, or both as desired. Connect the monitor to the mount and route wire over to the fuse box location. Connect red wire (power) to source found at fuse box during the pre-installation test. Connect black wire (ground) to suitable nearby ground.

Mounting the 7 " LCD Monitor:
Find a suitable location for the monitor for visibility and easy of use. With the universal mounting kit provided the monitor can be mounted on the dash or to the overhead. When selecting the location be sure to consider where and how the cable will be run. Mount the universal mounting plate with the adhesive, 4 screws, or both as desired. Connect the monitor to the mount and route wire over to the fuse box location. Connect red wire (power) to source found at fuse box during the pre-installation test. Connect black wire (ground) to suitable nearby ground.

Mounting the Adapter:
Find a suitable location for the adapter. When selecting the location for the adapter box, ensure that the power leads will reach the fuse box and the RCA cable will reach the monitor. Also consider how and where you will run the cables. The box can be mounted with double sided adhesive tape available from your local auto parts store or with tie-wraps or your own desires. With key in the on position (ignition off) use a test light to find a suitable 12 volt power source in the fuse box. Connect red wire (power) to source found at fuse box. Connect black wire (ground) to suitable nearly ground. Connect the RCA cable between the adapter box and your monitor.

Pre-Test Be sure to do this before beginning installation
Installing the Camera(s)
Final Connections